[Aurora-sparc-user] IRQ problems

[Kyle Gordon]

Total newbie question, but I can't find the answer anywhere:

I have two NICs installed trying to set up a firewall, but they are
both trying to nab the same IRQ. I added this to my silo.conf:
 append="ide=nodma ether=5,0xe000,eth0 ether=7,0x10000,eth1 rhgb quiet"

And both cards still try to grab the same IRQ of 6. One is the
on-board ethernet slot from a Sun Blade 100 and the other is a Compaq
10/100 WOL. Neither as far as I can see have tabs to switch IRQs
around.